Formdex Uniflex

Formdex Uniflex

Price: Liên hệ

Related

Formdex Uniflex is a two component cementitious waterproofing system. It is a heavy duty waterproofing membrane that has excellent flexibility and strength. It is used in situations where movement or cracking of the substrate is anticipated. Formdex Uniflex can be applied to both horizontal and vertical surfaces and can be used against active and passive pressure.

 

Special Features

• 100% compatible to all masonry substrate

• Excellent adhesion to all masonry substrate

• Easy to apply

• Air cure

• Safe for use in potable water tank

 

Different Types

Formdex Uniflex is a heavy duty waterproofing membrane that has excellent flexibility and strength. Hence it is used in situations where movement or cracking of the substrate is occuring or anticipated. Should be used as a concealed system. Formdex Uni is a heavy duty waterproofing membrane that seals water, rain, ground water and masonry, concrete,plaster and similar substrates. In addition, its high build nature enables it to absorb shock transmitted through the topping material and allow some flexing between it and the substrate. Should be used as a concealed system.

 

Areas of Usage

• Wet areas

• Swimming pools and water

   features

• Decks and patios

• Driveways

• Lift pits

• Retaining Walls

• Underground shafts

• Foundation walls and footings

 

Application

Prior to application, ensure that the concrete is clean and sound. Damp the substrate without leaving behind puddles of water.

Areas with surface of low water pressure (such as wet areas, decks, planters etc):

Apply by roller or brush 2 coats of Formdex at spreading rate of 1.0kg/m2/coat. Allow at least 3 hours drying time between each coat. Approximate DFT thickness 1mm.

Areas with ground or high water pressure (such as swimming pools, ponds, basement etc):

Apply by roller or brush 3 coats of Formdex at spreading rate of 1.0kg/m2/coat. Allow at least 3 hours drying time between each coat. Approximate DFT thickness 1.5mm.

 

Detailing

Apply Formdex at 1.0kg/m2 making certain to dress up at least 150mm from the finished floor. Immediately roll a layer of fibreglass mat and apply another coat of Formdex at 0.5kg/m2

Dries in humid conditions

Dries well in humid conditions. Can be applied in enclosed or poorly ventilated conditioning

 

 

publics/download/FormDexUni1.pdf

Special Features

Wide Compatibility

May be applied on brickwood, concrete, stone and similar substrates

 

Excellent adhesion

Is 100% compatible to masonry substrate, has excellent adhesion to the substrate it is applied on

 

Flexibility

Formdex has high flexibility and can bridge cracks up to 2mm width

 

Easy Application

Applied using roller and brush. Can be applied on vertical and horizontal surface and on damp substrate