Lemax 4 mm P - GY

Lemax 4 mm P - GY

Price: Liên hệ

Related

Lemax  4 mm P membrane - GY film is improved versatility of ammunition, can be installed in all positions require operation at low temperature, anti-radiation and mechanical pressure medium.

Lemax  4 mm P membrane - GY can be installed in:

- Typically a layer roof system.

- Roof system combines two layers of reinforced fiberglass.

- Waterproofing for toilets and wet areas within buildings, concrete.

ADVANTAGES

- Easy Installation (equal to warehouse)

- High mechanical properties.

- Absolute Waterproofing

- Bending cold plastic from -2 ° C or higher.

- Works well in high temperature conditions.

- Adhesion on any surface.

- Anti-deformed well.

- Friendly environment.

Properties Test method Unit Typical values
MINERAL COUNTY GREY (GY) LEMAX BITUME WATERPROOFING MEMBRANE APP IMPROVEMENTS

Length

Width

Thickness

Volume on the mineral grains

EN 1848-1
EN 1848-1
EN 1849-1
EN 1849-1

m

m

mm

kg/m²

10

1

4

4;4,5;5

Soft spot ASTM D -36 ºC
≥ 150

The level of penetration 25ºC

60ºC

ASTM D -5

dmm
dmm

15 to 25

60 to 80

Cold plastic bending

Testing hot steam

Reinforced

EN 1109

EN 1110

ºc
ºC

0 to –2

120

Polyester fabrics, not knitted

The intensity maximum stretch along

horizontal

EN 12311-1

N/5cm
N/5cm

750
600

Maximum conductivity along

horizontal

EN 12311-1

%

%

≥ 40
≥ 42

The intensity of the maximum stretch ends along

horizontal

EN 12371-1

N/5cm

n/5cm

650
500
Water absorption EN 1107-1 % Maximum 0:15
Let the steam through EN 1931 μ 80.000
Adhesion to concrete EN 13596 N/cm² 40
Dielectric constant ASTM D-150
- 2.5
Dielectric strength - Kv/mm 14
The number of particles in the surface mineral loss ASTM D -4977 gm/m²
Less than 200

APPLICATION INSTRUCTIONS

Lemax lining method to the repository, fastened or glued to the substrate depending on the requirements of the project.

Do not drop or throw rolled coil during discharge.

To avoid inserting the membrane into the corners, so handling the edges covered with sand and cement cross at right angles.

Waterproof surface must be clean, dry, remove dust and smooth, with surface irregularities should do more layer of cement sand screed.

Before the membrane lining Lemax scan.

Spread the membrane and placed in line.

Ties inside each roll must be adjacent cover 10 cm and tie the end of each coil adjacent to the cover 15 cm.

Roll half the film without changing direction.

Slowly cover the membrane, at the same time all the hard bottom (The system fully mounted) with propane to warehouse until burning plastic membrane and gradually flow out, creates a bonding between film and substrate.

Then the storehouse and the end flap to create seams, hand print on the film down. Difficult to use caution, not so long at a difficult point.

With tilt, should the construction of low vertical edge of the roll so that orthogonal to the inclined surface, the covering flap must be placed above the mat before ....