A concrete plasticizer and retarder based on modified lignosulfonates used to produce good quality concrete. Complies with ASTM C494 Type D

Plastiment 96 is used in structural and mass concrete where long setting times and improved workability are required, such as projects with:

- Large pours, to prevent formation of cold joints

- Long travel times from the concrete plant to the site

- Difficult placing conditions and details

- High ambient temperature

CHARACTERISTICS

- Only set retarding, does not delay the hardening process.

- Allow substantial cement reduction compared to plain concrete

- Increase in ultimate strength

- Good control of slump loss even at elevated ambient temperature

- Reduced shrinkage and creep

- Chloride free, does not attack reinforcement steel

Dosage: 0.20 – 1.00 ltr per 100 kg of cement (Depend on Cement type & brand)

Typical dosage: 0.35 – 0.50 ltr. per 100 kg of cement

Compatibility: Possible to combine with all Sikament, Sika Aer, Sika Pump, Sikacrete PP1, but must be added separately to the mix and not pre-mixed prior addition.

Cement types:  All Portland cement including sulfate resistant cement

Dispensing: Plastiment 96 is either added to the gauging water prior to its addition to the dry concrete mix or added separately to wetted concrete mix, further 3 mixing should take place for at least 1 minute per m .

Overdosing: When overdosed, setting time will be extended, depending on cement content and temperature. Final strength will be not impaired.

HEALTH AND SAFETY

Avoid contact with foodstuffs and utensils. Avoid prolonged skin contact. In the event of contamination wash thoroughly with water. If the eyes or mouth are affected wash with clean water and obtain medical attention immediately.